555 / 556 Inverting Buffer (Schmitt trigger) or NOT gate

555/556 Inverting Buffer (Schmitt trigger) or NOT gate

555 inverting buffer circuit (a NOT gate)

NOT gate symbol

The buffer circuit's input has a very high impedance (about 1M) so it requires only a few µA, but the output can sink or source up to 200mA. This enables a high impedance signal source (such as an LDR) to switch a low impedance output transducer (such as a lamp). It is an inverting buffer or NOT gate because the output logic state (low/high) is the inverse of the input state:

• Input low (< ¹/₃ Vs) makes output high, +Vs
• Input high (> ²/₃ Vs) makes output low, 0V

When the input voltage is between ¹/₃ and ²/₃ Vs the output remains in its present state. This intermediate input region is a deadspace where there is no response, a property called hysteresis, it is like backlash in a mechanical linkage. This type of circuit is called a Schmitt trigger. If high sensitivity is required the hysteresis is a problem, but in many circuits it is a helpful property. It gives the input a high immunity to noise because once the circuit output has switched high or low the input must change back by at least ¹/₃ Vs to make the output switch back.