Analogue and Digital Systems
|Analogue meter display|
Analogue systemsAnalogue systems process analogue signals which can take any value within a range, for example the output from an LDR (light sensor) or a microphone. An audio amplifier is an example of an analogue system. The amplifier produces an output voltage which can be any value within the range of its power supply.
An analogue meter can display any value within the range available on its scale. However, the precision of readings is limited by our ability to read them. For example the meter on the right shows 1.25V because the pointer is estimated to be half way between 1.2 and 1.3. The analogue meter can show any value between 1.2 and 1.3 but we are unable to read the scale more precisely than about half a division.
All electronic circuits suffer from 'noise' which is unwanted signal mixed in with the desired signal, for example an audio amplifier may pick up some mains 'hum' (the 50Hz frequency of the UK mains electricity supply). Noise can be difficult to eliminate from analogue signals because it may be hard to distinguish from the desired signal.
|Digital (logic) signal|
|Digital meter display|
Digital systemsDigital systems process digital signals which can take only a limited number of values (discrete steps), usually just two values are used: the positive supply voltage (+Vs) and zero volts (0V). Digital systems contain devices such as logic gates, flip-flops, shift registers and counters. A computer is an example of a digital system.
A digital meter can display many values, but not every value within its range. For example the display on the right can show 6.25 and 6.26 but not a value between them. This is not a problem because digital meters normally have sufficient digits to show values more precisely than it is possible to read an analogue display.